|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I purchased a vintage Sony mixer off eBay and within the hour was able to locate and purchase the manual for it.I mean really,where else can you find a manual for a product made in 1983!? It was easy to find and purchase/download the manual I needed.I will use this site again for other equipment I have! Great site!
;
manual de usuario perfecto y completo de buena calidad de impresion y muy detallado ideal !
 ;
It`s full copy of a service manual from url http://www.philips.owner-manuals.com/PM3216-service-manual-PHILIPS.html
;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
I. How the Cricket works A. Send unit: 1. OFF-ON: This switch turns the unit on and off. 2. LO-HI-SPKR: a. LO: Produces balanced low level output on the 1/4" balanced and XLR jacks with pin #1 and sleeve ground, pin #2 and tip positive, and pin #3 and ring negative. Produces balanced hi level output on the 1/4" balanced and XLR jacks with pin #1 and sleeve ground, pin #2 and tip positive, and pin #3 and ring negative. Produces a positive acoustic output from the internal speaker which is disconnected when the 1/4" unbalanced jack is used. This output will drive a speaker directly with tip positive.
B. Balanced cable fault indications. 1. An intact properly polarized device will light the green LED in the 2-T position and the red LED in the 3-R position. 2. If #1 or sleeve is open or there is a dead short between any two conductors, neither LED will light. 3. If #2 or tip is open, no LED will light in the 2-T position and the red LED will light in the 3-R position if #1/sleeve and #3/ring are intact and properly polarized. 4. If #3 or ring is open, the green LED will light in the 2-T position and no LED will light in the 3-R position if #1/sleeve and #2/tip are intact and properly polarized. 5. If #1/sleeve and #2/tip are reversed and #3/ring is intact, the red LED will light in the 2-T position. No LED's will light in the 3-R position. 6. If #1/sleeve and #3/ring are reversed and #2/tip is intact, the green LED will light in the 3-R position. No LED's will light in the 2-T position. 7. If #2/tip and #3/ring are reversed and #1/sleeve is intact, the red LED will light in the 2-T position and the green LED will light in the 3-R position. C. Unbalanced device continuity and polarity: 1. In the 2-T position the green LED should light. If the red LED lights, the circuit is reversing the polarity. If neither LED lights then there is either a short between #1/shield and #2/tip or an open circuit. 2. In the 3-R position most unbalanced devices ground these connections. Whatever the case, no LED's should light in this position. Quick reference charts are located on the bottom of the Send and Receive units. 10
b. HI:
c: SPKR:
B. Receive unit: 1. OFF-BAT-ON: This switch turns the unit on and off. With the switch in the BAT position, the green LED lights if the battery is good. Replace the battery if the green LED does not light or is very dim.
1
|
|
|
> |
|
